American Dryer Corp. D20 Uživatelský manuál

Service Proceduresfor the Model 20 Dryers(AD-20, SL20, CG20, D20, andSTI-8 Dryers GEN II)ADC Part No. 450261

10 American Dryer Corp. 450261-2Electrical Component LocationsELECTRICAL PANEL:The electrical panel is located behind the front upper panel.OVEN CONTA

450261-2 www.amdry.com 11FIRE SUPPRESSION SYSTEM ITEMSAND SAIL SWITCH:Rear of the dryer.DIRECT SPARK IGNITION (DSI) MODULE:Lower right front of the dr

12 American Dryer Corp. 450261-2EXHAUST PROBE, EXHAUST HI-LIMIT,AND LINT DRAWER SWITCH:Temperature probe and exhaust hi-limit areaccessible once the l

450261-2 www.amdry.com 13Belt InstallationRemove the back guard, front upper panel, and front lower panel. Cut the locking end off the plastic wire t

14 American Dryer Corp. 450261-2Pull the belt up through the tumbler felt until there is enough belt to begin to loop the belt around the tumbler(Fig.

450261-2 www.amdry.com 15Pulling the belt through the tumbler felt gap will tend to flip the felt. Before pulling the last few inches out of thetumbl

ADC Part No. 450261 2 - 09/15/05 - 1

IMPORTANT NOTE TO PURCHASERInformation must be obtained from your local gas supplier on theinstructions to be followed if the user smells gas. Thes

IMPORTANTYou must disconnect and lockout the electricsupply and the gas supply or the steam supplybefore any covers or guards are removed fromthe mach

4 American Dryer Corp. 450261-2Part Locations and RemovalUPPER FRONT PANEL REMOVAL:Remove the four screws located just above the loading door. Tilt t

450261-2 www.amdry.com 5BACK GUARD REMOVAL:Remove all facing visible screws.TOP COVER REMOVAL:With the back guard removed, the top is removedby pullin

6 American Dryer Corp. 450261-2LINT BOX / BLOWER ASSEMBLY REMOVAL (continued):Pull the lint box down from the front and out slightly.To remove motoriz

450261-2 www.amdry.com 7GAS VALVE REMOVAL:Be sure to shut off the gas main and then proceedto remove electrical connections and screwsindicated. Disc

8 American Dryer Corp. 450261-2TUMBLER SUPPORTWHEEL ASSEMBLY REPLACEMENT:The front wheel assemblies can be replaced withthe lower front panel removed.

450261-2 www.amdry.com 9TUMBLER ALIGNMENT:Proper alignment is achieved by making the gapbetween the tumbler and openings in the front andrear bulkhead